Replacement Of Non-Hot-Plug Components; Opening The Server - Fujitsu PRIMERGY RX200 S6 Operating Manual

CSS components
8.2

Replacement of non-hot-plug components

When a defective non-hot-plug component is detected (for more information,
see chapter "Starting up and operation" on page 61
Service (CSS)" manual on the ServerView Suite DVD 2), proceed as follows:
Ê Exit all applications and shut down the server properly (see section
"Switching the server on and off" on page
Ê Pull all power plugs out of the insulated sockets of the rack's internal power
supply.
Ê Remove the server from the rack (see section
in/from the rack" on page
8.2.1

Opening the server

You must remove the fan cover before removing the housing cover:
1
1
Figure 27: Opening the fan cover
Ê Push the two green buttons (1) in the direction of the arrow and lift the fan
cover up and off.
104
71).
45) and put the server on a table, for example.
Operating Manual
and the "Customer Self
"Installing/removing the server
2
RX200 S6