Table of Contents
Advertisement
Technical Specification
Cooking Hob
Cooking Zones
Supply Voltage
Power
Product Size
Cut Out Dimensions A×B (mm)
Dimensions are approximate. Because we continually strive to improve our products we may
change specifications and designs without prior notice.
Installation
Please affix data label provided on the adjacent cupboard near
the appliance for future reference. Thank you.
Selection of installation equipment
•
Cut out the work surface according to the sizes shown in the drawing.
•
For the purpose of installation and use, a minimum of 50mm space shall be preserved
around the hole.
•
Be sure the thickness of the work surface is at least 40-50mm. Please select
heat-resistant work surface material to avoid larger deformation caused by the heat
radiation from the hotplate.
•
When installing the hob over drawers, a board must be installed 10mm underneath the
hob. The board must be made of suitable heat resistant materials.
Cautions
1. The induction hotplate must be installed by qualified personnel or technicians. Never conduct
the installation by yourself.
2. The hob must not be installed directly above a dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the hob electronics.
3. The wall and induced heating zone above the tabletop must be able to withstand heat.
4.
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
L×W×H(mm)
Dear Installer:
HX-2-6NF-ZLIND
4 Zones
220-240V~ 50Hz
front left (180mm):2000W
rear left (180mm):1500W
rear right (180mm):2000W
front right (180mm):1500W
590x520x77mm
560x490mm
17
Advertisement
Table of Contents
