Chapter 3 Installation/Removal; Unpacking The 7F06-2 Module; Installing Fpims - Cabletron Systems SmartSWITCH 7F06-02 User Manual

Fddi smartswitch interface module

Hide thumbs Also See for SmartSWITCH 7F06-02:

Table of Contents

This chapter contains instructions for unpacking and installing the

7F06-2 Module in the:

• 7C03 MMAC SmartSwitch

• 7C04 Workgroup SmartSwitch

• 7C04-R Workgroup SmartSwitch.

Also included in the chapter are instructions the front panel FPIMs.

Unpack the 7F06-2 Module by using the following steps:

1. Carefully remove the module from the shipping box. (Save the

box and packing materials in the event the module must be

reshipped.)

2. Remove the module from the plastic bag. Observe all

precautions to prevent damage from Electrostatic Discharge

(ESD).

3. Carefully examine the module and check for damage. If damage

exists, DO NOT install the module; contact Cabletron Systems

Technical Support.

The 7F06-02 module is shipped without FPIMs. To install an FPIM,

follow the procedure below:

1. Remove the module if it is installed in the 7C03 MMAC

SmartSWITCH chassis by reversing the procedure in

Section 3.3.

2. Remove the blank front cover over the FPIM slot.

3. Install the FPIM as shown in Figure 3-1. Ensure that the rear

connector is seated ﬁrmly before tightening the two mounting

screws.

CHAPTER 3

INSTALLATION/REMOVAL

3-1

Table of Contents