TVS Apache RTR 160 4V Owner's Manual page 86

REAR WHEEL REMOVAL AND REASSEMBLY
Disc type:
1. Remove the wheel hugger rear.
2. Remove the axle nut (1) and along with the
washer and partially pull out the axle (2).
3. Take out the caliper assembly by dislocating it
from the disc and the swing arm lug.
4. Carefully hang the caliper assembly in the swing
arm itself. Take out the spacer and pull out the
axle fully.
5. Remove the wheel assembly by gently tapping it
along with the disc.
1
2
6. During re-assembly, engage the drum sprocket
with the wheel along with the drive chain and
then assemble the wheel into swing arm.
7 . Re-assemble the other parts in the reverse order
of removal.
Caution
While assembling the caliper assembly, ensure that the
slot provided in the caliper is properly located to the lug
provided in the swing arm assembly.
Always make sure that whenever the wheel is removed,
axle nut is properly re-tightened to the specified torque
and chain play is re checked and adjusted if required.
Note
During removal of rear wheel axle hold the drum sprocket
assembly with the hand as it may fall. Carefully hang the
drum sprocket along with chain in the swing arm itself.
83
83