TVS Apache RTR 160 4V Owner's Manual page 46

Setting the digital display
Every press of the Mode button changes the display
to other mode. Follow the below procedures to
change the display to desired mode.
If the ignition is turned 'OFF' while the cluster is in
'ODO' or 'TRIP' mode, then the respective meter will
be displayed during next ignition 'ON'. If any other
modes other than the above were set during ignition
'OFF', then 'ODO' meter will be displayed by default
during next ignition 'ON'.
1. In 'ODO' mode, press the Mode button once and
twice to enter '
respectively.
• To reset any of the trip meter while ensuring
the display is in 'TRIP 1' or 'TRIP 2', press and
hold the Set button for a few seconds.
2. In 'TRIP B' meter mode, press the Mode button
to enter high speed mode. On entering this
mode, a message '
high speed data will be displayed in the cluster's
display.
• To reset the high speed recorded, keep the
display in 'HIGH SPEED', press and hold the
Set button for a few seconds.
' and ' ' meters
' and last achieved
3. In 'TRIP B' meter mode, press the Mode button
twice to enter shortest time mode.
• To reset the 'LAST RECORD' of the shortest
time, press and hold the Set button for few a
seconds.
4. Press the Mode button once to change the
display to 'ODO' mode again.
Digital clock setting
1. Press and hold the Mode button till the 'Clock'
icon blinks in the display.
2. Now, press the Set button so that the hour digit
of the clock starts blinking.
3. Once again press the Mode button to increase
the hours while the hour digits of clock is blinking.
4. Now, press the Set button so that the hours is set
and the minute digits of the clock starts blinking.
5. Once again press the Mode button to increase
the minutes while the minute digits of the clock
is blinking.
6. Else, press the Set button to set the minutes of
the clock and the hour format 'AM' or 'PM' starts.
7 . Now, press the 'Mode' button to change the hour
format 'AM' or 'PM'.
43
43