TVS Apache RTR 160 4V Owner's Manual page 31

3. Clutch lever
Use the clutch lever to disengage the drive to the rear
wheel while shifting the gears. Squeezing the lever
towards grip disengages the drive.
4. Pass-by switch
Press the switch to flash the head lamp high beam. It
is used to give signal to the vehicles coming from the
opposite direction while overtaking other vehicles
during day.
The pass-by works only when the head lamp is
glowing in low beam. If the switch is pressed while
the head lamp is switched 'ON' and glowing in high
beam, there will be no change in beam of head lamp.
5. Beam control switch
The head lamp beam (high/low) can be controlled by
pressing the beam control switch.
Press the switch towards '
lamp high beam or press the switch towards '
turn-on the head lamp low beam.
Warning
Use appropriate head lamp beam 'high / low' as per the
traffic and road conditions for your safety and to avoid
inconvenience to other riders.
28
' to turn-on the head
' to
Note
Pass by system will not work if the head lamp is glowing
in 'High' beam.
The headlamp glows in low beam when the head lamp
switch is turned 'ON'. Only after the engine is started
the head lamp high beam will work provided if the beam
control switch is in high beam position.