Selecting A Stamp Effect - Edirol CG-8 User Manual

Creating patches

Selecting a Stamp Effect

Here's how to select the Stamp Effect you will use.
If you're creating the first Stamp Patch for a newly created project (p. 51), you will start
with this procedure.
1
Make sure that the [STAMP PATCH] pad is lit, and press the [EFFECT] pad.
If you want to switch banks, hold down the [EFFECT] pad, then press a visual pad [1]–
[16] to select the desired bank, and release the [EFFECT] pad.
The [EFFECT] pad will also light.
The display panel indicates the bank and number of the currently selected Stamp
Effect.
* If you're creating the first Stamp Patch for a newly created project, the display will indicate
"– –."
2
Press one of the lit visual pads [1]–[16] to select a Stamp Effect.
The Stamp Effect will change. The display panel indicates the bank and number of that
Stamp Effect.
3
If you want to keep your selection of a Stamp Effect, perform the Save operation (p.
83).
74
For details on Stamp
Effects, refer to "Stamp
Effects List" (p. 119).
While you continue
holding down the
[EFFECT] pad, the visual
pad corresponding to the
currently selected bank
number will blink.
The Stamp Effect will not
change if you press a
visual pad that is unlit.
Some Stamp Effects apply
an effect to the selected
Stamp Picture, while other
Stamp Effects are
themselves an image. If
you select one of the latter
type, the Stamp Effect will
determine the resulting
image regardless of the
Stamp Picture you
selected.