Applying An Effect To The Image - Edirol CG-8 User Manual

Basic operation

Applying an effect to the image

You can use the knobs and buttons shown below to modify the settings of the Photo
Effect and Stamp Effect. In this way you can apply a wide range of changes to the Photo
Patch image and Stamp Patch image.
fig.front08.e.eps
[MODULATION] knob
[RATE] knob
About the parameter knobs
The parameter knobs work in two different ways depending on the state of the
[DEPTH] button.
When the [DEPTH] button is off (unlit)
The parameter knobs will modify the image.
The [X] knob, [Y] knob, and [Z] knob will mainly change the position. The [SPEED]
knob adjusts the speed, the [COLOR] knob adjusts the color, and the [FADE] knob
adjusts the state of the fade. (Refer to the table on the next page.)
When the [DEPTH] button is on (lit)
The parameter knobs will adjust the modulation (cyclic change) of the image.
First, use the [MODULATION] knob to select the type of modulation (e.g., smooth
motion or random motion). Then, use the parameter knobs to adjust how that motion
is to occur. The [X] knob, [Y] knob, and [Z] knob will mainly change the direction of the
motion. The [SPEED] knob adjusts the speed of motion, and the [COLOR] knob adjusts
the color change (see the table on the following page). The [FADE] knob is not used
here.
The [RATE] knob adjusts the overall speed of modulation.
34
[COLOR] knob
[SPEED] knob
[DEPTH] button
[X] knob
[FADE] knob
Parameter knobs
[Z] knob
[Y] knob
If you've modified the
settings of an effect, you
can save your changes
together with the picture
as a Photo Patch or Stamp
Patch. For details, refer to
"Creating patches" (p.
61).