Table of Contents
Advertisement
Creating patches
Creating a Photo Patch
To create a Photo Patch, proceed as follows.
fig.front21.e.eps
[SAVE]
button
[PHOTO PATCH]
pad
[EFFECT]
pad
[PICTURE]
pad
Selecting a Photo Patch
Here's how to select the bank and number of the Photo Patch that you want to create
or edit.
* The following procedure is not necessary if you're creating the first Photo Patch in a newly
created project. Simply proceed to "Selecting a Photo Effect" (p. 63).
1
Press the [PHOTO PATCH] pad.
If you want to switch banks, hold down the [PHOTO PATCH] pad, then press a visual
pad [1]–[8] to select the desired bank, and release the [PHOTO PATCH] pad.
The [PHOTO PATCH] pad and any visual pads [1]–[16] to which Photo Patches are
assigned will light.
2
Press one of the lit visual pads [1]–[16] to select a Photo Patch.
The selected Photo Patch will begin playing. The display panel indicates the bank and
number of that Photo Patch.
62
Visual pads [1]–[16]
[PREVIEW]
button
While you continue
holding down the
[PHOTO PATCH] pad, the
visual pad corresponding
to the currently selected
bank number will blink.
The Photo Patch will not
change if you press a
visual pad to which no
Photo Patch is assigned
(i.e., an unlit pad).
Advertisement
Table of Contents
