Table of Contents
Advertisement
Basic operation
This section explains basic operation.
Turning the power on/off
941
* Once the connections have been completed, turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.
1. Connected equipment
2. CG-8
942
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power
up is required before the unit will operate normally.
Turning the power on
fig.front01.e.eps
[SHUTDOWN] button
1
Check the connections as described in "Basic connections" (p. 22), and turn on the
power of the display or monitor television that's connected to the CG-8.
2
Press the [POWER] switch located on the rear panel of the CG-8.
The [SHUTDOWN] button will light blue, and the CG-8 will begin starting up.
It will take a short time for the CG-8 to start up. (The display panel will indicate
"Load.")
When the CG-8 has started up, the display panel will indicate "– –".
Turning the power off
1
Press and hold the [SHUTDOWN] button for two seconds or longer.
The [SHUTDOWN] button will blink red/blue (shutdown in progress).
After a time, the [SHUTDOWN] button will light red (standby mode).
2
Press the [POWER] switch located on the CG-8's rear panel.
The [SHUTDOWN] button's light goes out.
945
* If you need to turn off the power completely, first turn off the POWER switch, then unplug
the power cord from the power outlet. Refer to "Power Supply" (p. 7).
26
[POWER] button
Before pressing the
[POWER] switch to turn off
the power, make sure that
the [SHUTDOWN] button
is lit red, indicating that the
CG-8 is in Standby mode.
When the [SHUTDOWN]
button is lit red, the CG-8 is
in Standby mode; the
power is not turned off. To
turn the power off
completely, press the
[POWER] switch so the
[SHUTDOWN] button's
illumination is turned off.
Advertisement
Table of Contents
