Creating a Stamp Patch
Here's how to create a Stamp Patch.
fig.front22.e.eps
[SAVE]
button
[STAMP PATCH]
pad
[EFFECT]
pad
[PICTURE]
pad
Selecting a Stamp Patch
Select the bank and number of the Stamp Patch that you want to modify to create your
own settings.
* The following procedure is not necessary if you're creating the first Stamp Patch for a newly
created project. Simply proceed to "Selecting a Stamp Effect" (p. 74).
1
Press the [STAMP PATCH] pad.
If you want to switch banks, hold down the [STAMP PATCH] pad, then press a visual
pad [1]–[8] to select the desired bank, and release the [STAMP PATCH] pad.
The [STAMP PATCH] pad and any visual pads [1]–[16] to which Stamp Patches are
assigned will light.
2
Press one of the lit visual pads [1]–[16] to select a Stamp Patch.
The selected Stamp Patch will begin playing. The display panel indicates the bank and
number of that Stamp Patch.
Visual pads [1]–[16]
Creating patches
[PREVIEW]
button
While you continue
holding down the [STAMP
PATCH] pad, the visual
pad corresponding to the
currently selected bank
number will blink.
The Stamp Patch will not
change if you press a
visual pad to which no
Stamp Patch is assigned
(i.e., an unlit pad).
73