Operation - Whirlpool 8LIECH-SCDSSFWL User Manual

OPERATION

IMPORTANT
The unit's self-cleaning feature prevents formation of Biofilm. The self-cleaning feature is
not intended for water purification.
This unit is intended for use with high-quality bacteriologically safe bottled water only. Do
NOT use other liquids. Do NOT use for other purposes. Warranty is void if unit is used with
any other liquids, including tap water, coffee, tea, juices, beer, or wine.
This dispenser has been designed to use with standard water bottles with a 3, 5, or 5.2
gallon capacity. Do NOT use alternative bottles.
Initial Set Up
Do NOT plug in until steps 1-3 are completed.
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. If unit was transported on its side, make sure unit is in the OFF position
and is upright for at least 4 hours prior to plugging the unit in.
2. This model uses a pump to deliver water from the bottle to the reservoirs:
i. Clean the bottle cap and neck.
ii. Remove the entire plastic cap from the bottle.
iii. Adjust the length of the probe by pulling the B portion of the tube to its
maximum extension. Insert the probe into the bottle and push it down.
The probe will self-adjust to its appropriate length. (See illustration on
right).
iv. Push down the probe head until it is seated.
v. Plug power cord into the wall outlet.
Note: At initial start-up, it will take less than 3 minutes to fill reservoirs with
water. If pump stops prematurely, please open and close the door to
activate reset using door switch.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-SCDSSFWL: Page 8
WARNING
Excessive Weight Hazard
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
A
B