Whirlpool 8LIECH-SCDSSFWL User Manual page 13

2. Attach or insert the probe to the bucket/bottle.
3. Place the bucket/bottle into the cooler and close the door. The water will be pumped up into the
holding tanks.
4. Plug in the cooler and turn on the hot switch located at the back of the cooler. Do not turn on the
cold-water switch.
5. Wait for 1 hour.
6. Unplug the cooler from the wall
7. Using rear drain plug, drain the water from the cooler into a bucket and discard the water.
A. Locate the white plastic cap at the back of the cooler.
B. Remove the screw.
C. Remove the clear silicone drain plug and allow water to drain out.
D. Reattach the drain plug and plastic cap before proceeding.
8. Fill the bucket/bottle with tap water and place into the machine.
9. Plug the cooler back into the wall, close the door and wait for 10 minutes.
10. Dispense water from both cold and hot faucets until smell from cleaning substances disappears.
11. Open drain plug and cap once again and drain all tap water.
12. Replace the drain plug and cap.
13. Place a fresh bottle of water into the machine and operate as usual.
14. This procedure must be repeated every 3 to 6 months, depending on mineral content and usage
of water cooler.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-SCDSSFWL: Page 13