Whirlpool 8LIECH-SCDSSFWL User Manual page 10

• The circular shapes in the drip plate help to align the flow of water. This unit dispenses
water quickly. To avoid splashes, hold the cup as close to the tap as possible.
2. Press the right control downward to start dispensing water.
3. Release the control once desired fill level is achieved.
Dispensing Hot Water
Note: After setup, hot water will be available in 15-20 minutes.
The Energy Saver Feature keeps hot water on standby at 80°C/176°F. Automatic Extra
Hot Booster is activated when 3 oz of water is drawn. Extra Hot water stays for at 90°C/194°F
for 2 hours before returning to Energy Saver mode.
1. Position the container you wish to fill with water securely below the hot-water tap.
• The left triangle below the hot water control indicates the location of the hot
water tap (See the "Parts & Features" section on page 5).
• The circular shapes in the drip plate help align the flow of water. To avoid splashes,
hold the cup as close to the tap as possible.
2. Push the hot water release button (red) inward and press the control downward to start
dispensing water.
3. Release the control once desired fill level is achieved.
Replacing an Empty Bottle
WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
Note: When your water bottle is empty, the dispenser will be intermittently and the LED night
lights will blink until a fresh bottle is connected.
You may also hear a sucking sound when the bottle is empty and needs changing. This is
normal and is another way to be alerted that your bottle is empty and needs to be replaced.
Replace the bottle as soon as you notice that it is empty. If a new bottle is unavailable, leave
the door ajar or unplug the cooler to stop the beeping noise and flashing lights.
1. Open the door and slide the bottle out.
2. Remove the probe by pulling it straight up until it is completely out of the bottle.
3. To install fresh bottle:
• Place the fresh bottle in front of the tray.
• Clean the fresh bottle using a soft cloth and warm soapy water.
• Remove the entire plastic cap from the top of the bottle.
• Insert the probe into the bottle.
• Push the probe down until it is sealed.
• Slide the bottle onto the tray and close the door completely.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-SCDSSFWL: Page 10