Operation - Whirlpool 7LIECH-SSF-WL User Manual

OPERATION

IMPORTANT
This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT use for other
purposes. Warranty is void if used with any other liquids such as coffee, tea, juices, beer or
wine.
This dispenser has been designed to use water bottles with a 3 or 5 gallon capacity. Do NOT
use alternative bottles.
Initial Set Up
Note: To avoid damage to the compressor, allow the unit to sit upright for at least 4 hours
prior to operation.
1. Remove the tamper seal from the bottle cap. Do NOT remove the plastic cap.
2. Clean the bottle cap and neck using a soft cloth and warm soapy water, then rinse after-
wards.
WARNING
Excessive Weight Hazard
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
3. Lift the bottle and insert onto the probe. Apply slight pressure until the plug inside the cap
pushes in and the bottle is seated. Water will begin to flow into the reservoirs, causing air
bubbles to form in the bottle.
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
4. Plug the cord into a properly grounded wall outlet.
5. Turn energy saving switch on back of dispenser to ON. This switch controls the heating of
water. If you do not want hot water, turn this switch OFF.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 7LIECH-SSF-WL: Page 7