Operation - Whirlpool 8LIECH-SCSSFP5W User Manual

OPERATION

IMPORTANT
This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT
use for other purposes. Warranty is void if used with any other liquids such as
coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with a 3, 5, or 5.2 gallon
capacity. Do NOT use alternative bottles.
Initial Set Up
Do NOT plug in until steps 1-2 are completed.
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. Allow the unit to sit upright for 4 hours. Make sure unit is in the off position and is upright
for at least 4 hours prior to plugging the unit in.
2. This model uses a pump to deliver water from the bottle to the reservoirs:
i. Clean the bottle cap and neck.
ii. Remove the entire plastic cap from bottle.
iii. Adjust the length of the probe by pulling the B portion of the tube to its
maximum extension. Insert the probe into the bottle and push it down.
The probe will self-adjust to its appropriate length. (See illustration on
right).
iv. Push down the probe head until it is seated.
v. Plug power cord into the wall outlet.
Note: At initial start-up, it will take about 3 minutes for the reservoirs to fill
with water.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-494-4757 for assistance.
Model # 8LIECH-SCSSFP5W: Page 8
WARNING
Excessive Weight Hazard
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
Stainless Steel
tube for Self - Clean
function
A
Expandable telescopic
tube for drawing water
from the bottle
B