Operation - Whirlpool 8LIECH-BP-WL User Manual

OPERATION

IMPORTANT
This unit is intended for use with high-quality bacteriologically safe bottled water only. Do NOT
use other liquids. Do NOT use for other purposes. Warranty is void if unit is used with any other
liquids, including tap water, coffee, tea, juices, beer, or wine.
This dispenser has been designed to use with standard water bottles with a 3, 5, or 5.2 gallon
capacity. Do NOT use alternative bottles.
Initial Set Up
Do NOT plug in until steps 1-3 are completed.
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in serious injury, fire, or
electrical shock.
1. If unit was transported on its side, make sure unit is in the OFF
position and is upright for at least 4 hours prior to plugging the unit in.
2. This model uses a pump to deliver water from the bottle to the reservoirs:
i. Clean the bottle cap and neck.
ii. Remove the entire plastic cap from the bottle.
iii. Adjust the length of the probe by pulling the B portion of the tube to
its maximum extension. Insert the probe into the bottle and push it
down. The probe will self-adjust to its appropriate length. (See
illustration on right).
iv. Push down the probe head until it is seated.
v. Plug power cord into the wall outlet.
Note: At initial set-up, it will take less than 3 minutes to fill reservoirs
with water. If pump stops prematurely, please open and close the door to activate reset
using door switch.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-BP-WL: Page 8
WARNING
Excessive Weight Hazard
Use two or more people to move and
install the water cooler and the bottles.
Failure to do so can result in back or
other injury.
A
B