Securam ScanLogic D66 Operation Manual page 5

Step 4: After ID01 fingerprint is verified successfully, press "▲" or "▼" to select "Enroll New User".
Step 5: Press "Menu/OK" again.
Step 6: Place the second enrollee's finger (different from the first one) on the fingerprint scanner
and hold.
The second fingerprint, with an ID No. 02, is enrolled successfully.
Note: ID No. 01 and ID No. 02 are administrators.
3.0 Enroll additional fingerprints (Security Level 3)
Step 1: Press "Menu/OK". The screen will show "Select Menu".
Step 2: Press "▲" or "▼" to select "System Menu". Press "Menu/OK" again.
Step 3: Place an enrolled administrator's finger (ID No. 01 or 02) on the scanner and hold.
Step 4: After the fingerprint is verified successfully, the LCD screen shows: "Select Menu", press
"▲" or "▼" to select "Enroll New User".
Step 5: Follow the Steps 5 and 6 in Section 2.0 to enroll additional fingerprints.
4.0 Set/Change User Code (Level 3)
The ScanLogic D66 is capable or registering not only fingerprints but also 6 digit codes for each
enrolled fingerprint. To Set or Change a User code, perform the following process:
Step 1: Press "Menu/OK". The screen will show "Select Menu".
Step 2: Press "▲" or "▼" to select "System Menu", press "Menu/OK" again.
Step 3: Place the user's finger on the fingerprint scanner and hold.
Step 4: After the fingerprint is verified, press "▲" or "▼" to select "Set/Change User Code", press
"Menu/Ok".
Step 5: When the screen displays "New Code", enter a 6 digit code.
Step 6: Enter the same 6 digit code again.
The new code is now set or changed successfully.
Note:
Administrators' code can be set or changed directly.
●
Non-administrators' code must be enabled by the administrator first, then, the user can set or
●
change their code.
If consecutive four digits of a new code (for example 512341) is the same as one of the enrolled
●
SECURAM Systems Inc. ScanLogic D66 Operation Guide Page 5