Mitsubishi HS-U776 Owner's Manual page 8

Hooking Up Your VCR
Connections to TV with Audio Video Inputs
Because you purchased a Hi-Fi VCR, you will want to take
advantage of its superior sound capability and connect it
to a stereo TV system with audio and video inputs. This
connection also helps maintain the best picture quality.
1 Connect the red and white audio cable to AUDIO
OUT R (right) and AUDIO OUT L (left) on the VCR.
Connect the other end to the TV's AUDIO IN
RIGHT and AUDIO IN LEFT. Match the colors of
the connectors to the cables.
2 Connect the yellow video cable to VIDEO OUT on
VCR. Connect the other end to VIDEO IN on the
TV .
3 To use S-video cable, connect it as shown.
4 Set the RF converter to OFF. See page 49 for
instructions on this setting, which can be done at a
later time.
VCR Rear Panel
R AUDIO L
R
Red White Yellow
6
OUT
VIDEO S-VIDEO
supplied S-video cable
It is not neccesary to connect yellow video cable
if you connect an S-Video cable. However, we
recommend to connect it to prevent the contact
between plug and other jacks.
supplied audio/video cable
TV Rear Panel
Your TV Owner's Guide may have additional
suggestions for audio video hookups.
To connect your VCR to a mono (non-stereo) TV,
connect only the white AUDIO OUT L of the VCR
and the white AUDIO INPUT of the TV. Since the
TV is not stereo, you cannot take advantage of your
VCR's Hi-Fi stereo sound.
If you have an older TV without audio video inputs,
simply connect only the antenna or cable as shown
on the previous page.
White
Yellow
INPUT-1
INPUT-2
OUTPUT
MONITOR/TUNER
L (MONO)
S-VIDEO VIDEO
IMPORTANT
IMPORTANT
Red
R
R
AUDIO