Table of Contents
Advertisement
Timer Recording
Canceling a timer recording before the recording starts
1
Press MENU on the remote control. Your VCR will turn on and VCR Main
Menu will appear on your screen. Use the ADJUST buttons on the remote
control to select Program to record. Press ENTER.
2
Recap screen will display for 4 seconds. While this screen is displayed,
press the ADJUST buttons to place the cursor next to the program you
wish to cancel.
3
Press CANCEL. The program is erased.
4
Press MENU twice to turn off the menus.
Using a satellite receiver
If you are using a Panasonic, RCA, Sony, Toshiba, or Hughes satellite receiver,
your VCR will turn the receiver on when a timer recording begins and off when
the recording ends.
However, if you are using a PRIMESTAR
have to turn the receiver on before a timer recording begins.
Before turning off the VCR, to put your VCR in stand-by for recording, make
sure that your satellite receiver's menu turns off.
You can watch satellite channels through your VCR even when the VCR is
turned off but only if you connected your VCR and TV with an S-Video cable
and the Rear S-through in the S-VHS Set-Up menu is set to ON. If you used a
standard video cable, you can only view satellite channels through your VCR
when the VCR is on.
TIMER RESET
You can use TIMER RESET on the rear panel to erase both the clock and all
timer recordings.
To use TIMER RESET, press it with a pencil or a ball point pen. The power will
turn off and the clock will be cleared. All timer recordings are erased.
If you have set the Clock set setting of the Set the clock menu to AUTO, the
auto clock function will automatically set the clock again.
Memory backup
If the VCR is without power for 30 minutes or less, it will retain the clock and
the programmed settings. The VCR must have been plugged in for at least an
hour beforehand to charge this backup. If the power is lost for more than 30
minutes, the time and the programmed settings will be lost.
If you have set the Clock set setting of the Set the clock menu to AUTO, the
auto clock function will automatically set the clock again when power is
restored.
®
or DISH Network
™
receiver, you will
Recap screen
¬Program to record
CH DAY
ON
§
2 MO13 11:30a 1:30pSP
--- --
--:-- --:-- SP
--- --
--:-- --:-- SP
--- --
--:-- --:-- SP
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER
to enter
∑ ππADJUST to select
VCR Rear Panel
TIMER RESET
TIMER RESET
OFF
35
Advertisement
Table of Contents
