Cabletron Systems SmartSwitch Router 520 Installation And Configuration Manual page 65

[5] Go To Local Console
This selection runs quick configuration. If you reset to factory defaults and
select Go to Local Console without having configured the router via
the installation menu, the qconfig process starts automatically.
After making the changes you want, exit quick configuration and apply the
changes you made by typing restart. The system displays the following
messages:
If you type restart at the Config (only)> prompt, the following message
displays:
Config (only)>restart
Are you sure you want to restart the gateway? (Yes [No]):
Enter yes to proceed. The following menu is then displayed.
SmrtSwtch Rtr 5xx
==================================================================
==================================================================
Quick Config Done
Type RESTART at Config (only)> prompt for the configuration to
take effect.
Config (only) >
SmrtSwtch Rtr 5xx INSTALLATION MENU
**************************************************
To fully manage this device telnet to one of the
following IP addresses or select item [3] below.
Out-of-Band: Not Configured
In-Band
**************************************************
[1] Restart with Factory Defaults
[2] Restart with Current Settings
[3] Go to Local Console
Enter selection :
: 134.1.147.150
Configuring the Router
4-19