Feed Dogs & Stitch Length; Feed Dog Height & Tilt; Feed Dog Front-To-Back Position - KANSAI SPECIAL RX9701J Series Instructions Manual

【4】FEED DOGS & STITCH LENGTH
4 4 4 4 - - - - 1 Feed dog height & tilt 1 Feed dog height & tilt
1 Feed dog height & tilt 1 Feed dog height & tilt
■Height
When the feed dog is at the top of this stroke, the
feed dog teeth should be parallel with and
1.0~1.2mm above the top surface of the needle plate.
To make this adjustment, loosen screw A and move
the feed dog up or down.
■Tilt
When the feed dogs are at their top of their stroke,
the feed dogs should be parallel with the top surface
of the needle plate.
loosen screws D and move shaft E. If the fabric to
be used is thick and soft, install the feed dogs
slightly higher than standard to feed the fabric
smoothly.
4 4 4 4 - - - - 2 2 2 2 Feed dog front Feed dog front- - - - to to to to- - - - back position
Feed dog front Feed dog front
The feed dog should be centered front to back.
The feed dog should not touch the needle plate.
Fine adjustment is made by tightening screw G and
turning front-to-back adjusting eccentric F
To make this adjustment,
back position
back position back position
6