Shoulder Guards; Seat Belts - Can-Am DEFENDER MAX Series 2021 Operator's Manual

EQUIPMENT
tmo2016-010-160_a
1. Side net adjustment locations
2. Shoulder guard

8) Shoulder Guards

The vehicle is equipped with shoulder
guards to help restrain the entire body
of driver and passengers inside vehi-
cle.

9) Seat Belts

This vehicle is equipped with 3 points
seat belts to help protect driver and
passengers in the event of a collision,
rollover, or tipover. The seat belts can
help keep occupants stay in the pas-
senger compartment.
WARNING
Wear seat belts properly at all
times. Seat belts reduce the
risk of injury in a crash and help
keep limbs inside the cockpit in a
rollover or any accidents.
If driver's seat belt is not fastened
when:
– The ignition is turn ON, the seat belt
indicator lamp will flash.
– The engine is started and shift
lever is moved out of PARK, vehicle
speed will be limited to a maximum
of approximately 20 km/h (12 MPH)
on flat ground.
WARNING
The vehicle may reach higher or
lower speed depending on in-
clines.
______________
92
To remind you to fasten the seat belt,
the multifunction gauge will display the
following message: ENGINE LIMITA-
TION ENGAGED FASTEN SEAT BELT.
WARNING
There is no indicator light or mes-
sage for the passengers seat belts.
The driver is responsible for the
passengers safety and should en-
sure the passengers buckles their
seat belts.
Fastening and Adjusting the Seat
Belt
The seat belt is equipped with a semi-
cinching tab that lock the lap belt when
the webbing is under tension.
tmr2014-037-005_a
TYPICAL
1. Semi-cinching tab
To fasten the seat belt, insert the latch
plate into the buckle, then pull the belt
to ensure it is properly fastened.
Adjust the seat belt tightly against your
body by pulling the shoulder belt up-
wards.