Can-Am DEFENDER MAX Series 2021 Operator's Manual page 81

219002117-001
TYPICAL
1. Upper button
2. Lower button
Setup
Using LOWER button, Select SET-
TINGS and hold to enter setting menu.
Maintenance Reset
NOTE: Only when the maintenance is
due.
Using LOWER button, Select RES
MAINT and hold to reset maintenance.
Fault Codes
NOTE: Only when codes are actives.
Using LOWER button, Select CODES
and hold to see actives fault codes.
Fault codes will be scrolled on the
Lower Display.
Reset Stats
Using LOWER button, select RESET
STAT and hold to reset.
Unit Selection
This multifunction gauge is factory pre-
set in Metric units but it is possible to
change it to Imperial units.
Using LOWER button, Select UNITS
and hold button to change units.
Setting Clock
Using LOWER button, Select CLOCK
and hold to adjust clock.
1. Press LOWER button to select clock
display.
2. Push and hold LOWER button for 1
second.
3. Press LOWER button to select
12:00 AM PM or 24:00 time base.
4. Push and hold LOWER button to ac-
knowledge selection.
5. Press LOWER button to change
hours (hours flash).
6. Push and hold LOWER button to ac-
knowledge hour selection.
7. Press LOWER button to switch to
minutes (minutes flash).
8. Push and hold LOWER button to ac-
knowledge minutes selection.
Setting Language
The gauge display language can be
changed.
Can-Am dealer for language availability
and to setup the gauge to your prefer-
ence.
Setting Brightness
The brightness of the LCD display can
be adjusted.
Using LOWER button, select BRIGHT-
NESS and hold button to change
brightness.
Using LOWER button, adjust bright-
ness then push and hold LOWER but-
ton to acknowledge selection.
_______________
4.5" DIGITAL DISPLAY
Refer to an authorized
79