Table of Contents
Advertisement
4.2
Electrical equipment
4.2.1
Motor
4.2.2
Operating modes
4.2.3
Junction box
ELHY-Montageanleitung_2021_EN.docx
A three-phase asynchronous motor is used for the drive. The power
supply is provided via screw terminals that are located in a junction
box.
Two-pole three-phase asynchronous motor
Standard insulation according to insulation class F
Special version in insulation class H
Continuous operation S1 and intermittent operation S3 - 100 %
ED (duty cycle) standard
Differing technical values for ambient temperatures > 40 °C
For further information on the deviating technical values, please
contact EMG Automation GmbH.
Information on the connections can be found in the technical data (⇒
chapter Technical data, section Follow-up training).
Cable entry
The junction box is equipped with an M25 x 1.5 cable infeed for the
following line parameters:
Cable diameter 7.5 mm to 18 mm, with protection class IP66 for
cable diameters from 11 mm to 16 mm
Conductor cross-sections up to 4 x 2.5 mm
Functional description
Electrical equipment
2
4
4.2
33 / 71
Advertisement
Table of Contents
