Yaesu FTM-3200DR Quick Manual

FTM-3200DR
Quick Manual C4FM/FM
1 2 3
VOL
DIAL
SQL REV D/A M H z V / M
TXPO D W SETUP M W
10 9 8 7 6 5 4
1 VOL knob
2 LCD display
3 DIAL knob
4 Power/LOCK key
5 V/M MW key ( )
6 MHz SETUP key ( )
7 D/A GM key ( )
8 REV DW key ( )
9 SQL TXPO key ( )
10 External MIC jack
EH052N550
Inputting/changing the call sign
Inputting the call sign
When turning the transceiver on for the first time after
purchase, or after resetting the transceiver, a screen
requesting input of your call sign appears.
Press , then rotate the DIAL to input the call sign.
You can move the cursor to the right by pressing
Press for over one second to register the input call
sign.
Supplement By rotating the DIAL, you can switch the
characters in the following order:
"space" à " - " à " / " à 0 to 9 à A to Z
Note that "space", " - ", and " / " are not
selectable for the first character.
Changing the call sign
The call sign can be changed from the Setup menu.
Press and hold for over one second, then rotate
the DIAL to select "MY CALL 53" and then press
Rotate the DIAL to select the desired character. You
can move the cursor to the right by pressing
inputting the call sign, press and hold for over one
second.
Returning to the operating screen
Press and hold for over one second to return to the
operating screen from the Setup menu.
Supplements • Press to return to the previous
screen.
• Press and hold
ond to return to the operating screen.
Restoring defaults (All Reset)
All transceiver settings and memory content may be
restored to the default settings.
Turn the power OFF.
While pressing , , and
.
ON.
When "ALL RESET PUSH V/M KEY" appears, release
the keys.
Press to reset.
Adjusting the volume
Rotate the volume clockwise/counterclockwise to adjust
the volume level.
Tuning in to the frequency
Press to switch to VFO mode, then rotate the DIAL.
Press to make the first three digits of the frequency
.
display blink, then rotate the DIAL to set the frequency
by one MHz increments.
. After
Selecting communication mode
For normal use, operate the transceiver in AMS mode
(The " " icon blinks). The operating mode automati-
cally switches to match the received signal.
Press to manually change the communication
for over one sec- mode.
"ANALOG (No icon appears)" à "AMS (The "
blinks)" à "DN (The "
DN: Calls are less prone to interruptions due to
detection and correction of voice signals
during digital voice signal transmission.
ANALOG: Analog communication using FM mode. Ef-
fective when the signal is weak and audio is
, turn the power
susceptible to interruption in digital mode.
Changing the transmit power level
Press and hold
DIAL to select the transmit power level.
"HIGH" à "LOW" à "MID"
Press to set the transmit power level.
" icon
" icon lights)"
for over one second, then rotate