Yaesu FTM-3207DE Operating Manual page 37

After successfully connecting to the node, one of the following screens is displayed
indicating the node status.
r 1.Node ID screen (the Node Lc screen)
• This screen is displayed if the node is
disconnected from the other node or the
room on the Internet.
• The node station's node ID is displayed.
• Continue to select a connecting node à proceed to step 6
r 2. Connecting to a node ID or room ID-
screen (the Cn screen)
• This screen is displayed when the node
has been connected to a node or room
on the Internet.
• The connecting node station's node ID is displayed.
• If not changing the connecting node/room à proceed to step 7
• When changing the connecting node/room à proceed to step 6
Note:If the node connection is not successful, the beep sound is emitted and the transceiver
returns to the normal operation.
6. Rotate the DIAL knob to select one of the connection screens (see below information),
and connect to the desired node/room.
Node ID screen
(the Node Lc screen)
Direct entry screen
(the En screen)
r The most recent connected node ID or
room ID screen (the C0 screen)
Most recent connected node ID or room
ID is displayed. A single press of the [#]
key on this screen will connect to the
most recent node/room.
r Registered node ID or room ID screen
(the C1-C5 screen)
Rotate the DIAL knob to select a previ-
ously registered node/room (maximum 5
nodes/rooms) on the C1-C5 screen and,
then press the [#] key or the PTT switch to
connect to the node/room.
FTM-3207DR/DE Operating Manual
Connecting the WIRES-X feature
Connecting to the node ID or
room ID screen (the Cn screen)
The most recent connected node ID
or room ID screen (the C0 screen)
Registered node ID or room ID
screen (the C1 - C5 screen)
37