Faema E71 E Use And Installation page 56

11. Description display symbols
Water LeveL
This symbol indicates the boiler water level.
During the loading phase, the bottom part of the
icon blinks.
When the optimum level is reached, the symbol
looks like this:
resistance
This symbol indicates that the resistance is
activated and functioning; a thicker luminous flow
passing through the resistance shows the electric
heating is on.
When the boiler pressure reaches the set value,
the icon looks like this:
This indicates that the heating resistance
has been disabled.
note: the customer cannot switch on or switch
off the electric heating.
When the on/off function is programmed, the
electric heating takes place automatically.
sevice boiLer Pressure
This symbol indicates the boiler pressure
value.
If the icon
pressure gauge will be displayed analogically.
This will be shown on the display:
Press again the icon
regular display mode.
.
.
is pressed, the
to return to the
cuP-Warmer
Wifi
WIFI connection symbols:
- network present but not connected;
- connected to the network.
bLuetooth
These symbols refer to Bluetooth communication:
- the white icon indicates the presence of the
Bluetooth module on the machine;
- the white icon on blue background indicates that
the machine is communicating with a Bluetooth
grinder/dispenser.
usb
This symbol appears on the display when
a USB pen drive is connected.
sD
This icon indicates the presence of an SD micro
chip in the CPU board of the machine.
Payment systems
This icon indicates that the machine is connected to a
payment systems interface and is configured to work with it.
Dispensing is therefore possible subject to approval by the
payment system.
- the grey icon indicates that the cash system has
denied the transaction;
- the white icon indicates that the cash system
has approved the transaction.
controL of the fLoW (onLy if in use)
When this icon lights up it means that it is necessary
to adjust the grinder-dispenser to tighten or loosen the
grinding, in order to return the coffee dose to the correct
parameters.
The icons that are shown are:
means that the grinding needs to be loosened.
(flow of coffee is lower than the reference).
means that the grinding needs to be tightened.
(flow of coffee is greater than the reference).
Note. The number next to the icon (1 or 2) indicates the
grinder-dispenser that must be used.
The icon appears on the display instead of the level symbol.
12 EN
These symbols indicate the
power currently selected by
the cup warmer.