Section 3. Sonic Ruptor 400 Set-Up; Preparing The Sonic Ruptor 400 For Use - Omni SONIC RUPTOR 400 User Manual

8
SECTION 3. SONIC RUPTOR 400 SET -UP

3.1 PREPARING THE SONIC RUPTOR 400 FOR USE

Please read and follow these instructions carefully before operating the
Omni Sonic Ruptor 400.
Place the control unit on a flat surface, using the same care as with any electronic device.
Avoid placing the control unit near flammable vapors and water.
Attaching the Processing Tip (Sold Separately)
Remove the protective plastic caps from the Processing Tip and the Transducer exposing the
Mating Surfaces. Ensure the Mating Surfaces of the Tip and Transducer are free of dirt and/or
oils.
Place one 1.5" diameter
plastic Interface Washer,
P/N 18-420-001 (included)
between the Tip and the
Transducer assembly.
CAUTION: Always place a washer between the Tip and the BNC Transducer.
CAUTION: Never apply grease or oil to the threads of the Transducer or the Tip.