Table of Contents
Advertisement
Version 1.2
Fitting the hinge screws
and spacers, prior to
mounting the door.
4.10 Smartrack door
The door mounts on the left side of the rack, and supports all the rack electronics.
Mounting the Smartrack door is the last part of the installation procedure.
4.10.1 Mounting the door
a)
Remove the door from its packaging.
b)
Using the two hinge screws and 3.5mm
spacers provided, mount the door in the
Smartrack chassis.
Tip: Extend the bottom screw fully, slide
on a spacer, and fit into place first. Then,
with the top screw protruding 3-4mm, fit
top spacer, locate top mounting and
screw top screw home.
Note that the fit of the bottom mounting is
deliberately loose. This tightens automati-
cally when the door is closed and
screwed shut.
4.10.2 Connecting earth and power wiring
a)
Connect front door earthing wire to the adjacent stud in the chassis,
using an M4 nut runner.
b)
Route the CPU power loom and terminate to the power terminal block,
following the coding labels on the loom wires.
c)
Fix the clear plastic cover of the power terminal block in position,
using the M5 taptite screws provided.
4.10.3 Smartrack CPU jumper settings
Set the three jumpers J1, J2 and J3, according to the power rating of the
power assemblies in the top, middle and bottom positions in the rack:
Smartrack User Manual
door spacer
hinge screw
page 27
Advertisement
Table of Contents
