Standard Smartrack - ETC SMARTRACK User Manual

Smartrack User Manual
NOTE: If the mains circuit breaker option (MCCB) is not fitted, adequate protec-
tion must be installed upstream of the Smartrack(s).

4.5.1 Standard Smartrack

Standard racks require a five wire supply, terminated in eyelet (ring) lugs,
to fit the M12 terminal screws provided.
a)
b)
page 16
Run the power wires into the power terminal block, via the top or bot-
tom cable entry on the left side of the rack. Cable tie anchors are pro-
vided just inside the cable entry ports.
Note that a cable way, with slots for cable ties, is provided to lead
power wires up and down the left side of the enclosure to feed other
Smartracks above or below.
Trim to length and terminate with M12 clearance lugs. Do not fit the
plastic terminal block cover at this stage.
ETC Ltd