Advertisement
Available languages
Available languages
5.8.
Press the
5.9. When the function "Adaptive temperature change" is active, the thermostat will
advance the heating, so that the desired temperature has been reached at the sched-
uled time. By default, the function is on.
External Temperature Control
5.10. You can use external temperature control, if external voltage is connected to the
thermostat.
•
Disable / Enable the function from "Settings / External control".
•
From "Temperature" you can set the desired temperature value. The default tem-
perature setting for external control is 10 °C.
"Temperature change" can be either a rise or a drop in the set point temperature.
•
•
The blue LED indicator A is on when the temperature change is in use.
•
If the external control is enabled you cannot use the adjustment wheel for setting
temperature.
Resetting the Factory Settings
5.11. Reset the factory settings:
•
Press the adjustment wheel C on the thermostat.
•
After 7 seconds, the blue LED indicator A starts to blink quickly.
•
Paired devices, consumption information and calendar settings are removed. The
thermostat is in "Floor" mode.
6.
Battery
6.1.
The purpose of the battery is to maintain the time during power cuts. If the clock
does not keep correct time, the battery must be replaced. The battery change interval is
several years and is usage dependent.
The battery may only be replaced by a skilled or instructed person.
Disconnect the power supply before replacing the battery.
6.2.
Replace the thermostat battery, figure 6.
•
Remove the thermostat cover carefully by using a screwdriver.
•
Replace the battery with the same type of battery as the original, CR1225.
•
Put the cover in place.
•
Dispose of the empty battery according to local recycling guidelines.
7.
Figures
1. Connection diagram
2. User interface
3. Installing the Ensto Heat Control application
4. Pairing the thermostat with your mobile device
5. Ensto Heat Control Home display
6. Replacing the battery
7. Dimensions
24 / 64
button on home display to enter the editing mode.
RAK128 / 10.6.2021
Advertisement
