Configuring Dip Switch Settings - Casio DT-X10 Series User Manual

Configuring DIP Switch Settings

A bank for DIP switches is located on the bottom of the Satellite Cradle.
You can change the on/off settings of the DIP switches to configure the Satellite Cradle
to meet your needs. After you change DIP switch settings, the new settings do not go
into effect until you turn the Satellite Cradle off and then back on again.
1 2 3 4 5 6 7 8
Important !
Note that other DIP settings are used for testing and inspection purposes. Because
of this, you should never use any DIP settings other than those described above.
E-38
Not used (Always off)
Not used (Always off)
Host Computer Interface
Setting
RS-232C
USB
Daisy Chain
Setting
Intermediate Unit
Daisy Chain Disabled/End Unit
Connection Type
Setting
Host Computer
Daisy Chain
Satellite Cradle Data Rate
Setting
115,200bps
*Initial factory default setting
6
OFF
ON
*
5
OFF
ON
*
3 4
OFF OFF
*
ON OFF
1 2
ON OFF
*