Casio DT-X10 Series User Manual page 35

5. Drive the other screw into the wall at the location where the lower hole is located.
6. Drive the upper screw and lower screw into the wall the rest of the way.
To remove the Satellite Cradle from the wall
1. Loosen the upper screw and lower screw.
2. Raise the Satellite Cradle and remove if from the screws.
Important !
• While the Satellite Cradle is mounted on a wall, be sure to check the wall screws
periodically for looseness. Tighten them as required.
• Note that RS-232C connection is not supported by the wall-mounted. Connect
using a USB cable or daisy chain cable.
E-40