Dip Switch Setting For Ha-A61Io - Casio DT-X5 Series Hardware Manual

2.5 DIP Switch Setting for HA-A61IO

The DIP switch is located on the rear side of the Bridge Satellite Cradle. Change the ON/OFF settings according to
your required system configuration. The new settings do not go into effect until the power switch is turned off and
then back on again.
Note:
Other DIP switch settings are used for testing and inspection purposes. Because of this, you should never use any
DIP settings other than those described above.
ON（Upper side）
OFF（Lower side）
Not used (Always set to "OFF")
Not used (Always set to "OFF")
Host computer interface
Interface
RS-232C
USB *
Termination setting for daisy chain connection
Termination
At middle
No chain/Termination*
Connection mode
Mode
With Host PC*
Chain connection
Communication speed between Cradles
Baud rate
115,200bps *
* : Default setting.
Fig. 2.3
30
6
OFF
ON
5
OFF
ON
3 4
OFF OFF
ON OFF
1 2
ON OFF