Proxim Edge MP-1015-CPE Hardware Installation Manual page 15

2. To connect the device through a hub or a switch to a Personal Computer, connect an Ethernet cable between the
network interface card in the Personal Computer and the hub, and between the hub and the RJ45 IN / LAN port on
the PoE Injector.
3. To connect the device directly to a Personal Computer, connect an Ethernet cable between the network interface card
in the Personal Computer and the RJ45 IN / LAN port on the PoE Injector.
: Edge device is supplied with a 30W passive PoE injector. It can also be powered up via 802.3af/at power injector or
switch.
Step 10: Install Surge Protector
TM
Edge 10xx Series products comes with a built-in Ethernet surge protection; however, it is mandatory to install an approved
lightning surge protector at the building ingress point. Moreover, if you are installing the device in a region subjected to
violent thunderstorms or severe weather conditions, then installation of an additional approved lightning surge protector near
the device is recommended.
: The Surge Arrestor (Part Number 235-00001) is not provided with the Proxim's Package Contents, it needs to be
procured by the customer. To buy an additional Surge Protector, place an order separately with your distributor.
Perform the following steps to ensure proper surge protection:
1. Mount a surge protector near the building ingress and use 12 AWG or larger wire to connect the surge protector's
ground lug to earth ground.
2. The outdoor device and co-located surge protector (optional) should have a common grounding point using the
shortest possible grounding cable.
TM
Edge Multipoint and Quickbridge - Hardware Installation Guide
Figure 4-5 Cable Plugged In
Device Installation
15