Proxim Edge MP-1015-CPE Hardware Installation Manual page 14

1. To pole mount the device, insert the two Hose Clamps through the hose clamp slits at the bottom of the Device. See
Figure 5.
2. Place the device against the pole and tighten the hose clamps to the pole.
Step 8: Plug in the Cables
1. Plug one end of the straight-through Cat5e cable into the Ethernet Port of the device by following the procedure
explained under
port on the PoE Injector.
TM
Edge Multipoint and Quickbridge - Hardware Installation Guide
Figure 4-3 Pole Mounting (MP-1015 & MP-1025)
Figure 4-4 Pole Mounting (MP-1035)
Step 5: Weatherproofing RJ45
Connection. Connect the other end of the cable into the OUT / POE
Device Installation
14