Device Installation; Installation Procedure - Proxim Edge MP-1015-CPE Hardware Installation Manual

Device Installation

4.1 Installation Procedure

This section describes the steps to install and mount the device(s).
: The device must be installed by a trained professional who is familiar with radio frequency planning and
regulatory limits. Please refer
Perform the following steps to install and mount the device
Step 1: Plan for Installation
There are several planning factors to be considered before installing the device. In addition to selecting the installation site,
you should do the following:
Calculate:
Required RSL (Receive Signal Level) and fade margin to achieve link availability objectives. For more details on how to
•
calculate RSL and fade margin, please refer to the
• Required path availability
Anticipated multi-path reflection points
•
Determine:
• System frequency plan
Required antenna mounting height to obtain proper path clearance
•
• Required transmission line types (like RF cable, waveguides) and lengths
Plan for:
Device's continuous power consumption needs
•
• Lightning protection and system grounding
• Hardware mounting
Cable installation including ingress
•
Pre-testing equipment (back-to-back test)
•
Step 2: Choose a Location
To make optimal use of the device, you must find a suitable location to install the hardware. The range of the radio device
largely depends upon the position of the antenna. Proxim recommends you do a site survey, observing the following
requirements, before mounting the hardware.
• The location must allow easy disconnection of power to the radio, if necessary.
• Ensure free flow of air around the hardware.
The radio device must be kept away from vibration and excessive heat.
•
The installation must conform to local regulations at all times. For details, please refer to
•
Information.
The devices are designed to directly mount to a pole. By using the supplied brackets and hardware, you can mount them to
a 1.5 to 3-inch pole (outside diameter). Longer bolts (not supplied) are required to mount the device to a larger diameter pole
(upto 4.5 inches). By using the same pole mounting bracket, you can mount the device to a wall or other flat surface.
TM
Edge Multipoint and Quickbridge - Hardware Installation Guide
Safety & Regulatory Information
Antenna Installation
for details.
and Measuring Signal
Safety & Regulatory
4
Performance.
11