Certification And Safety Approvals; Fcc Compliance Statement - Sena SP38 User Manual

20S
Type Function Button Command
Play/Pause
Press the Jog Dial
Bluetooth
for 1 second
music
Music
Track forward/ Rotate the Jog Dial
back while pressing
Press the Phone
FM radio on Button for 2
seconds
Press the Phone
FM radio off Button for 2
seconds
Tap the Phone
Select preset
Button
FM radio
Rotate the Jog Dial
Seek stations
while pressing
Scan up FM Double tap the
band Phone Button
Double tap the
Stop scanning
Phone Button
Save preset
Tap the Phone
while
Button
scanning
Press the Phone
Button for 12
Factory reset
seconds
Reset
Tap the Jog Dial within 5 seconds
Press the Reset
Fault reset
Button
64
Voice
LED Beep
Command
Mid-tone
"Music" -
double beeps
"Next"/
- -
"Previous"
Mid-tone
"FM radio" -
double beeps
"FM radio"/ Mid-tone
-
"Stop" double beeps
"Next"/ Mid-tone
-
"Previous" single beep
High tone triple
- -
beeps
- - -
High tone
- -
double beeps
High tone
- -
double beeps
High tone
- Solid red
double beeps
- - -

CERTIFICATION AND SAFETY APPROVALS

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antennae
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.