Sena PowerPro Mount Manual

Also See for PowerPro:

Table of Contents

Introduction

PowerPro Mount

Handlebar Mount

USB Power Cable

Installation Step 1
Installation Step 2
Installation Step 3
Installation Step 4
Installation Step 5
Installation Step 6
Installation Step 7

Release Step 1
Release Step 2

NOTE:
* It takes 6.5 hours to fully charge the PowerPro Mount when using standard USB cable.

NOTE:

To begin charging, press the Power Button after you connect the USB power cable.
To find out the battery level during use, tap the Power Button. The LED indicator will light up to show the Remaining battery level.
Sena PowerPro Mount is compatible with 5V input USB-charged devices only.

Keep the product free of dust. It may damage mechanical and electronic parts of the product.
Do not store the product in high temperatures as this may reduce the life span of electronic devices, damage the battery, and/or melt plastic parts of the product.
Do not store the product in cold temperatures. Abrupt changes in temperatures may cause condensation and damage electronic circuits.
Do not clean the product with cleaning solvents, toxic chemicals, or strong detergents as this may damage the product.
Do not drop or otherwise shock the product. It may damage the product or its internal electronic circuits.
Do not disassemble, repair or modify the product as this may damage the product and invalidate the product warranty.
Do not store the product in humid environments, especially for long time storage.

Do not cause impact to the product or touch it with sharp tools as this may damage the product.
Do not use the product in high-temperatures or apply heat to the product as this may cause damage, explosion, or fire.
Keep the product dry and away from water. It may damage the product.
Keep product away from pets or small children. It may damage the product or cause accidents.
Do not use the product near a microwave oven as this may cause malfunction or interference with the product.
Do not use the product near hazardous explosives. When there are near any explosion hazards, unplug the USB cable and heed any regulations, instructions, and signs in the area.
If the product is damaged, stop using it immediately. It may cause damage, explosion, or fire.

Therefore, when using the product, make sure to adhere to the following:

The battery performance may be reduced over time with usage.
In recharging the battery, make sure to use an approved charger provided by the manufacturer. Use of a non-approved charger may cause fire, explosion, leakage, and other hazards may also reduce the life time or performance of the battery.
Store the battery at temperatures of 15°C~25°C (59°F~77°F). Higher or lower temperatures may reduce the capacity and life of the battery, or may cause temporary non-operation. Do not use the product in sub-zero temperature, because it may cause serious reduction of the battery performance.
If you apply heat to the battery or throw it into fire, it may explode.
Never use a damaged charger. It may explode and/or

Rating: 3.63V / 10000mAh
Charging voltage: 5V
Charging current: 2A
End voltage: 5V
Discharging current: 2000mA
Battery Capacity: 10000mAh
Input: 5V / 2A
Output: 5V / 2A
Operating temperature: 10°C ~ 45°C
Weight: 249 g
Size: 80.8 mm x 122 mm x 62.7 mm
Charging time: 6.5 hours (given 2A adapter)
Safety: Overcharging protection, over-discharging protection, temperature protection