Stihl TS 700 Instruction Manual page 21

7 Assembling the bearing and guard
► Turn the guard so that it is in the position
shown (see picture)
► Screw in and tighten the stop pin (1)
► Insert the sealing plug (2)
► Move the adjusting lever (3) to position A
► Insert and tighten the screw (4)
2
► Turn the "support with guard" so that the guard
is on the outboard side
► Insert the square nut into the guide in the
guard and hold it in place
► Screw in the shorter banjo bolt (5) and washer
at the adjusting lever and tighten up with the
combination wrench
► Insert the sealing plug (2)
► Insert and tighten the screw (4)
7.3.6 Mounting "support with guard" – guard
on the outboard side
► Fit the "support with guard" (1) on the out‐
board side of the cast arm - at the same time,
guide the V-belt over the belt pulley
0458-572-0121-E
4
5
1
3
2
4
NOTICE
The belt action must run smoothly.
► Position the V-belt guard (2)
► Align studs (3) in support with nuts (4) in the
V-belt guard
► Screw nuts (4) onto studs (3) – do not tighten
them yet
7.3.7 Connecting the water connection
3
1
2
1
► Insert the longer banjo bolt (1) through the
connector (2) of the water attachment –
observe the position of the connector
► Insert the square nut into the guide in the
guard and hold it in place
► Fit the support with the longer banjo bolt on
the adjusting lever (3) – screw in the banjo bolt
and tighten with the combination wrench
English
21