Stihl TS 700 Instruction Manual page 20

English
7.3.2 Removing the adjusting lever
3
2
► Unscrew the banjo bolt (1) with the combina‐
tion wrench and remove it together with the
seal – in the process, remove the square nut
from the inside of the guard from the guide
► Unscrew the screw (2)
► Turn the adjusting lever (3) upwards and
remove
► Remove the sealing plug (4)
7.3.3 Slackening the V-belt
2
► To relax the poly V-belt, loosen the nuts (1) –
do not unscrew the nuts (1) from the studs
► Turn the tensioning nut (2) counterclockwise
with the combination wrench –
approx. 1/4 turn, as far as it will go = 0
► Unscrew nuts (1) from the studs – nuts (1) are
fastened to the belt guard so that they are
secured against loss
20
1
4
1
1
1
7 Assembling the bearing and guard
7.3.4 Removing the V-belt guard
2
► Pull the V-belt guard (1) off and remove the V-
belt (2) from the front pulley (3)
► Remove the "support and guard" (4)
7.3.5 Preparing the "support with guard" for
outboard mounting
2
► Unscrew the stop pin (1)
► Remove the sealing plug (2)
2
1
4
3
1
1
4
3
A
0458-572-0121-E