Stihl TS 700 Instruction Manual page 18

English
7.1.6 Mounting "support with guard" – guard
on the outboard side
► Fit the "support with guard" (1) on the out‐
board side of the cast arm - at the same time,
guide the V-belt over the belt pulley
NOTICE
The belt action must run smoothly.
► Position the V-belt guard (2)
► Align studs (3) in support with nuts (4) in the
V-belt guard
► Screw nuts (4) onto studs (3) – do not tighten
them yet
7.1.7 Connecting the water connection
3
1
2
1
► Insert the longer banjo bolt (1) through the
connector (2) of the water attachment –
observe the position of the connector
► Insert the square nut into the guide in the
guard and hold it in place
18
1
3
2
4
7 Assembling the bearing and guard
► Fit the support with the longer banjo bolt on
the adjusting lever (3) – screw in the banjo bolt
and tighten with the combination wrench
7.1.8 Checking the adjustment range of the
guard
► Rotate the guard forwards and backwards as
far as possible – adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter "Tensioning
the V-belt".
7.2 Inboard mounting (TS 700)
► Disassemble the abrasive wheel (see "Fitting /
replacing an abrasive wheel")
► Remove the water attachment
► Remove the adjusting lever
► Slacken the V-belt
► Remove the V-belt guard
► Remove "support with guard"
A
0458-572-0121-E