Stihl TS 700 Instruction Manual page 11

3 Sample Applications
– water tank usable on the cut-off machine cart
for binding dust
3.3 Observe with diamond and
composite resin abrasive
wheels
3.3.1 Objects to be cut
– Must be fully supported
– Must be secured so it cannot roll or slip off
– Must be prevented from vibrating
3.3.2 Severed parts
With openings, recesses, etc., the sequence of
the cuts is important. Always make the last cut
so that the abrasive wheel does not become jam‐
med and so that the operator is not endangered
by the severed or separated part.
If necessary, leave small ridges that hold the part
that is to be separated in position. Break these
ridges later.
Before finally separating the part, determine:
– how heavy the part is
– how it can move after separation
– whether it is under tension
When breaking out the part, do not endanger
assistants.
3.4 Cut in several passes
► Mark cutting line (A)
► Work along the cutting line. When making cor‐
rections, do not tilt the abrasive wheel, but
0458-572-0121-E
always set the abrasive wheel against the
workpiece anew – the cutting depth for each
operation should not exceed 5 to 6 cm. Cut
thicker material in multiple operations
3.5 Cutting plates
► Secure the plate (e. g. on a non-slip surface,
sandbed)
► Grind a guide groove (A) along the line
marked
► Make the cut (B) deeper
► Leave a "hinge" (C)
► First sever the plate at the cut ends so that no
material breaks away
► Break plate
► Make curves in multiple operations – make
certain that the abrasive wheel does not tilt
3.6 Cutting pipes, round and hollow
bodies
► Secure pipes, round and hollow bodies
against vibrations, slipping and rolling away
English
11