Installing The Driver In A New System With Other Hardware - Adaptec ASR-2000S Installation Manual

4
Shut down the system and remove the Adaptec RAID
Installation CD and the driver floppy disk.
5
Insert the Windows NT setup media (floppy disk or CD) and
restart the system.
6
If prompted, skip Setup's mass storage detection. Press S to
Specify Additional Devices.
7
Select Other, then insert the driver disk you created in
8
Select Adaptec I
9
Press Enter and continue with the installation as described in
the Windows NT documentation.

Installing the Driver in a New System with Other Hardware

In this scenario, you are installing an Adaptec RAID controller in a
new computer system with another controller from another
manufacturer or other hardware that requires the use of
Windows NT mass storage detection. To install the driver
1
Create a driver disk using the Adaptec RAID Installation CD. To
create a driver disk
a
Insert the Adaptec RAID Installation CD in your drive.
b
Boot from the CD. The CD loads a Linux kernel that is used
to manage all of its functions.
c
Follow instructions and respond to prompts as necessary to
get to the Adaptec splash screen.
d
When you see the Adaptec splash screen, click Create
Driver Disk. Then, click the appropriate operating system.
e
Insert a floppy disk and click OK. The system creates the
driver disk.
2
Shut down the system and remove the Adaptec RAID
Installation CD and the driver floppy disk.
3
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
O RAID Host Adapter Driver for NT 4.0.
2
Installing the Driver
Chapter 2.
Step 3.
3-7