Table of Contents
Advertisement
Windows 95, Windows 98, and Windows Me
The following installation scenarios are discussed:
Installing the Driver in a New Windows 98/Me System on
page 3-12
Installing the Driver in a New System with Windows 95 (OEM SR2
– Version 95B) on page 3-14
Adding the Controller to an Existing Windows 95/98/Me System on
page 3-16
Upgrading Windows 95 to Windows 98/Me (Upgrade Version) on
page 3-18
Creating the Driver Disk
Each of the procedures for installing the driver in each case requires
a slightly different procedure. However, all the procedures require
you to create a driver disk. To create the driver disk
1
Insert the Adaptec RAID Installation CD in your drive.
2
Boot from the CD. The CD loads a Linux kernel that is used to
manage all of its functions.
3
Follow instructions and respond to prompts as necessary to get
to the Adaptec splash screen.
4
When you see the Adaptec splash screen, click Create Driver
Disk. Then, click the appropriate operating system.
5
Insert a floppy disk and click OK. The system creates the
driver disk.
6
Shut down the system, and remove the Adaptec RAID
Installation CD and the driver floppy disk.
Installing the Driver
3-11
Advertisement
Table of Contents
