AKCP sensorProbe2 User Manual page 29

SP2/SP4/SP8/SP8-X20 Manual
Depending on which version of sensorProbe2 you have your System page may appear different.
The sensorProbe2 units that were shipped prior to October of 2009 have the older memory
mega128 chip. If this is the case your screen will appear like the screen shot shows above. This
st
System page will also show in the sensorProbe8 interface on units shipped prior to July 1 2011.
Important Note: The sensorProbe4 units all use the AT-Mega256 memory.
Note: To allow the User to login without having to enter a password use "public" in the SNMP get.
The User web interface login password is the same as the SNMPget community and the Admin is
the same as the SNMPset\get community string. You set your web interface login passwords in
the SNMP community settings by enabling the "Password checking" above then entering your
passwords into these fields.
Admin Password Problems - If you are experiencing an issue where you are getting logged out
of the web UI, then cannot log back in please try the following.
Send the request to support for the master log in password along with the MAC ID of your unit
and use this to log back into the units web UI.
When you have the "use the same password for web interface and SNMP" enabled (YES). Then
if you want to change the Admin password you would change this in the SNMPset community as
this will also be used for the Admin log in password if this is set to YES.
(continued on next page)
Updated until firmware 476 - 29 -