Advertisement
Problems updating firmware that is very old to the latest release.
You may experience a problem when trying to update your sensorProbe2 or sensorProbe8 to
the latest firmware if the firmware on your base unit has not been updated for a very long
period of time NOTE: This does not apply to the sensorProbe4 units as they use the newer
256 AT-mega memory.
If you try to update your unit and receive this error below in the IPSet utility, then you will
need to update your unit in one or two steps, depending on how old the firmware version is
you are running on the unit. It is important to use the same IPSet version that is included in
each firmware package and not the latest version.
Please download either of these older versions of firmware depending on if you have a
sensorProbe2 or sensorProbe8 unit, then update the unit with each and then to the latest
version that is on our web site.
1st sensorProbe2 update: -
2nd sensorProbe2 update: -
1st sensorProbe8 update: -
2md sensorProbe8 update: -
Updated until firmware 476
http://www.akcp.com/wp-content/uploads/2010/04/SP2_371.zip
http://www.akcp.com/wp-content/uploads/2010/04/SP2_398.zip
http://www.akcp.com/wp-content/uploads/2010/04/SP8_371.zip
http://www.akcp.com/wp-content/uploads/2010/04/SP8_398.zip
- 14 -
SP2/SP4/SP8/SP8-X20 Manual
Advertisement
Need help?
Do you have a question about the sensorProbe2 and is the answer not in the manual?
Questions and answers