Table of Contents
Advertisement
Center Slip Clutch
Maximum Setting
L = 1.125 (1-1/8")
Wing Slip Clutches
Normal Setting
L = 1.063 (1-1/16")
Maximum Setting
L = 1031 (1-1/32")
Mower Frame
Frame Pivot Points: Grease every 2 days, locations listed below:)
(1)
Hitch Clevis
(1)
Hitch Swivel
(2)
Hitch Frame
(2)
Link Rod
(3)
Wheel Standard
(3)
Main Lift
(5)
Wing Lift
Wing Wheel Standards: Grease every 2 days, 1 grease point under each wing fender.
Wheel Hubs: Grease every month, 4 locations, 2 on the Center Section Hubs and 2 on wing wheel hubs. Fill
until grease is seen purging at the bearings seals.
HUBS AND SPINDLES
Check hubs weekly for bearing play and condition of seal.
Greasing and Installation
It is recommended that hubs are dismantled, cleaned and repacked every year. Use the diagram and following
instructions for maintaining the wheel hubs. Whenever a worn or damaged seal is replaced the bearing
assembly should be cleaned and repacked with a good grade of wheel grease.
Always wear protective gloves when handling grease.
V1280 07/16
© 2016 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-13
Advertisement
Table of Contents
