Installing And Removing A Power Supply; Installing A Power Supply; Removing A Power Supply - Acer Altos S700 Series User Manual

78
Installing and Removing a Power
Supply
The power supplies are located in the rear of the enclosure. Follow
these procedures to install and remove the power supplies.

Installing a Power Supply

1 Select the power supply slot into which the power supply is to be
inserted and remove the carrier blank if there is one installed.
2 Orient the power supply, such that the LEDs are on the top (on the
right hand side for rack mount systems).
3 Gently slide the power supply into the empty power supply slot.
4 Secure in place using the two fixing screws (torque setting 0.3Nm).
5 Install the power cable.

Removing a Power Supply

1 Turn off the power supply, and remove the power cable.
2 Loosen the two fixing screws.
3 Using the power supply handle, gently slide it out of the enclosure.
Caution: Immediately replace the power supply carrier or install a
power supply carrier blank to maintain correct airflow.
Figure 6-3 Power Supply
Chapter 6 Installing and Removing Components
AC
Handle
Inlet
On/Off
Switch